Solder Sucker / Desoldering Pump
Used to remove excess solder during pc board repairs or salvaging of components.
Allows One Handed operation.
How to use your solder sucker:
- Push the set knob down to load the solder sucker, until it locks in place.
- Melt the solder at the solder joint to be removed.
- Aim the Nozzle close to the joint whilst the solder is melted.
- Push the release button.
- Repeat if necessary.
Maintaining your solder sucker:
- Remove the set knob to again access to cylinder.
- Pull out the entire plunger with O-ring.
- Unscrew / Unlock the soldering tip.
- Discard any excess solder.
- Clean the inside of the cylinder from top to bottom.
- Mount the soldering tip again.
- Coat the cylinder internally with a light layer of o-ring friendly grease.
- Coat the Plunger and O-ring seal with the same grease.
- Return set knob and plunger into position.
NB. Final product may look different, but will have similar operation.
Solder Sucker
- Product Code: Solder Sucker
- Availability: 5
-
R55.00
Related Products
Tags: solder, soldering iron, soldering station, rework, repair, component removal, component replacement, service